Step 1) Locate the two base pieces and the lower pedestal. Notice the notches in the lower pedestal that correspond with the flanges on the base pieces. Insert the two base pieces into the lower pedestal so that the flanges mount into the notches.

Step 2) Locate the two pedestal inserts. Insert them into the top of the lower pedestal 

Step 3) Insert the top pedestal over the pedestal inserts until snug

Step 4) Remove the single thumb screw on the top pedestal, place ring light on top and then secure with the thumb screw

Step 5) Connect power supply brick to cable in the back of ring light

Part 2: Initial Software Setup