HootBooth 11” Illumin8+ Assembly Guide
Loosen single thumb screw on back of Ring Light Assembly, open unit.
![page1image17889504](https://s3.amazonaws.com/cdn.freshdesk.com/data/helpdesk/attachments/production/17086526846/original/9Oj5FRAAJu5qEbZqucSGcMuGB-k5d1w3nQ.jpeg?1646163579)
![page1image17884720](https://s3.amazonaws.com/cdn.freshdesk.com/data/helpdesk/attachments/production/17086526844/original/K2CKKZKLvrMH9S8SVNS6eLUABSvcuY9kKg.png?1646163579)
Remove 8 wing nuts from iPad housing, flip housing over.
Insert iPad, and secure with the two small tabs, one on each side. Flip the housing back over and replace 8 wing nuts
Connect iPad USB-C cable into the open USB-C slot
Reassemble assembly and tighten single thumb screw on back
Secure Bottom Pedestal to Base Plate via 2 thumb screws
Secure Top Pedestal to Bottom Pedestal via 2 thumb screws
Attach Ring Light Assembly to Top Pedestal via 3 wing nuts
Connect power cable
Run power cable through bottom of pedestal
Place pedestal covers on back of pedestals to hide internal wiring