Getting Started: HootBooth® ILLUMIN8 Models

Getting Started: HootBooth® ILLUMIN8 Software (PixBooth2) Guides
You should follow these steps to successfully set up your HootBooth ILLUMIN8 with PIxBooth2 by Curator Software: Setting up the PixBooth2 by Curator sof...
Mon, 16 Nov, 2020 at 7:20 PM
Getting Started: HootBooth® ILLUMIN8+
Follow the attached guide for assembling your Illumin8+
Mon, 16 Nov, 2020 at 7:20 PM
Assembly Guide: HootBooth® ILLUMIN8 Version 1.0 (If purchased prior to Nov 20, 2018)
You may view the attached photos to assemble your HootBooth Illumin8 Unit: Use the two provided thumb screws to secure the Pedestal to the Base Piece ...
Mon, 16 Nov, 2020 at 7:19 PM
Getting Started: HootBooth® ILLUMIN8 ROVR/ Programming LEDs
Part 1 - Assembly 1) Install your 10.5" iPad.      Open the back of the top piece by removing the 8 thumb screws     Insert your iPad and attach ...
Mon, 16 Nov, 2020 at 7:21 PM
Assembly Guide: HootBooth® ILLUMIN8 Version 2.0 (If purchased after Nov 20, 2018)
You may view the attached photos to assemble your HootBooth ILLUMIN8 Unit: Use the two provided thumbscrews to secure the Pedestal to the Base Piece S...
Mon, 16 Nov, 2020 at 7:22 PM
Getting Started: How To Pay 'Per Event' (Not Using a Subscription) In PixBooth2 by Curator
If you did not purchase a Software Subscription for Curator, or simply wish to pay on a Per Event Basis you may follow the guide below: Step 1: Create y...
Mon, 16 Nov, 2020 at 7:23 PM
Illumin8 Version 3.0 LED Programming Guide
Note: The LED is only programmable on later Illumin8 models and the Illumin8 ROVR. The Illumin8+ model uses a solid white LED. Trigger Operation: T...
Thu, 12 Sep, 2019 at 3:52 PM
Getting Started: How To Apply A Custom Overlay To Your Photo Template
When you modify an experience in PixBooth2 by Curator, you will be provided a list of pre-made templates that you can modify.  In your 'Customize E...
Mon, 16 Nov, 2020 at 7:25 PM