Getting Started: HootBooth® Assembly, Initial Setup and Packaging Guides
Assembly of HootBooth® units
Power Consumption: The peak current draw of our models with all accessories running is 5.5 amps. A standard 120 volt outlet is sufficient. Hoo...
Wed, 3 Nov, 2021 at 10:46 AM
Please view the attached document showing the set up of the printer shelves and tray.
Sat, 27 Jan, 2024 at 12:33 PM
The following are suggestions you should consider when you or your team are ready to begin running events with your HootBooth Photo Booth: Above all, es...
Mon, 4 Feb, 2019 at 8:33 AM
All HootBooth models use a variety of thumb screws and plastic grommets. If you need these quickly you may refer to the guide below. These components can al...
Sat, 27 Jan, 2024 at 12:34 PM
At some point you may be asked to or want to display a legal disclaimer for all guests. They must read and agree to your terms before they are allowed to se...
Tue, 21 Jan, 2020 at 11:41 AM
Below can be found a series of tips and information bites on how to ensure your Wi-Fi will be there to support you throughout your Event Crowds mean busy c...
Thu, 13 Feb, 2020 at 10:19 AM
Find Spin-Arm and two thumb screws as shown below: Slide Lower Bracket into opening below platform. Secure with thumb screws: Find Power...
Wed, 27 Oct, 2021 at 11:30 AM
Note: This guide is for Illumin8 360 models purchased after July 25, 2021 Remove large thumb screw below: Pull pedestal upright to desired ...
Tue, 7 Sep, 2021 at 9:30 AM
LumaVu Assembly Guide Assembly: Locate the 4 wheels for the base piece and turn base piece over. Screw the wheels in by hand, ensuring that the tw...
Thu, 15 Sep, 2022 at 8:51 AM
Step 1) Locate the two base pieces and the lower pedestal. Notice the notches in the lower pedestal that correspond with the flanges on the base pie...
Tue, 16 May, 2023 at 10:43 AM