Note: The LED is only programmable on later Illumin8 models and the Illumin8 ROVR. The Illumin8+ model uses a solid white LED.
Trigger Operation:
- There are 3 'modes' you can use for lighting using the Red button on the back
- Unit will turn on in Rainbow Mode. This can serve as an attractor when no one is using the booth
- Press trigger one time to advance to White light. This serves as the best lighting for photo captures
- Press trigger again to advance to colored lighting, which can be programmed via the steps below
Programming:
- From Startup, press and hold trigger button for 5 seconds. This puts the ROVR into Standby mode (turns the lights off)
- While in Standby mode, press and hold button for 5 seconds. This puts the ROVR into Programming Mode
- The first section to program is Rainbow mode. You will choose the intensity of the rainbow chase one press at a time. Double press the trigger to save your preference
- The second section to program is the White light intensity. Choose the intensity of the White light one press at a time. Double press the trigger to save your preference
- The last section to program is the Colored Lighting. Single press the trigger through the colors. Double press to save your preference
- Press the trigger 4 times to exit Programming mode
- Your preferences are now saved